ldap_list

Parameters

link_identifier

An LDAP link identifier, returned by ldap_connect().

base_dn

The base DN for the directory.

filter

attributes

An array of the required attributes, e.g. array("mail", "sn", "cn"). Note that the "dn" is always returned irrespective of which attributes types are requested.

Using this parameter is much more efficient than the default action (which is to return all attributes and their associated values). The use of this parameter should therefore be considered good practice.

attrsonly

Should be set to 1 if only attribute types are wanted. If set to 0 both attributes types and attribute values are fetched which is the default behaviour.

sizelimit

Enables you to limit the count of entries fetched. Setting this to 0 means no limit.

Note: This parameter can NOT override server-side preset sizelimit. You can set it lower though.
Some directory server hosts will be configured to return no more than a preset number of entries. If this occurs, the server will indicate that it has only returned a partial results set. This also occurs if you use this parameter to limit the count of fetched entries.

timelimit

Sets the number of seconds how long is spend on the search. Setting this to 0 means no limit.

Note: This parameter can NOT override server-side preset timelimit. You can set it lower though.

deref

Specifies how aliases should be handled during the search. It can be one of the following:

• LDAP_DEREF_NEVER - (default) aliases are never dereferenced.
• LDAP_DEREF_SEARCHING - aliases should be dereferenced during the search but not when locating the base object of the search.
• LDAP_DEREF_FINDING - aliases should be dereferenced when locating the base object but not during the search.
• LDAP_DEREF_ALWAYS - aliases should be dereferenced always.